- Messages
- 54
- Reaction score
- 3
Have I got this right?
I put a backing washer above the plate (figured it couldn't hurt) which is compressing the factory/OE bushing. Since there's no bottoming out I figure it's a 'feel' thing in terms of how much compression/deformation I should end up with?
On the underside of the tower I installed just a backing washer and the plate.
[Reposting from Restorations sections, oops]
I put a backing washer above the plate (figured it couldn't hurt) which is compressing the factory/OE bushing. Since there's no bottoming out I figure it's a 'feel' thing in terms of how much compression/deformation I should end up with?
On the underside of the tower I installed just a backing washer and the plate.
[Reposting from Restorations sections, oops]