Thanks IanPut me down for a set of the aluminum ones.
PLEASE.. Notify me when they are available for purchase as I need two sets one for my 73 and 76 E9.I’ve done a little research into getting these mounts made from milled aluminium. (Original part pictured below)
It is still in the planning stage and the current figure for a pair in smooth, unfinished aluminium is around $140USD which may decrease depending on volume.
These would be supplied unpainted so as to be finished to your taste and standard.
I am told that the aluminium being used to make them would best be suited to an anodised finish rather than powder coating.
If there is enough interest to get them made turn around would be some time in the early new year.
Let’s see where this goes...
No problem Jack I have added you to the list and keep you updated.PLEASE.. Notify me when they are available for purchase as I need two sets one for my 73 and 76 E9.
Thank you.
Jack
From memory there was someone already reproducing these at a reasonable price, so I feel there wouldn’t be a very big market for them.Frankie, any chance of the inner clips being reproduced? I'd be down for 2 sets and I'm sure many others would be interested
I have shipped these all over the world including Spain in the past. I’ll send you a PM with detailsIm in for a set if you could arrange delivery to Spain.
I want a set asap
Hi Frankie, I would like another set too. Thank you!I have a few sets available. I’ve sent you a PM
Hi Frankie, I would like another set too. Thank you!