In the past I think I used a slide hammer and drilled a hole, but I don't want the chips falling down the block and my motor is still in the car so the slide hammer will be difficult. Anyone have a favourite DIY method?
Tia.
Tia.
hi i can not help cause i do not know what are you talking about:o
Bob I did mine by using a punch large enough that it didn't puncture but it sufficiently rotated it such that I could grab it with vise grip pliers and rotate it back and forth a bit until it slides out.
The Freeze plugs are the circular metal pieces that keep the coolant in the block and pop out if the coolant freezes. There are quite a few on an M30 Block.
That is what I'll do. Thanks Luis. What type of sealant did you use with the new plug?
hi i can not help cause i do not know what are you talking about:o