The '71 2800A we have came with only the rear half of the driveshaft so I think I need to source a complete driveshaft to use in the five speed conversion. I'm guessing the driveshaft needs to come from an e9 so that the CSB will mount to the original tunnel supports. Or, are there other driveshafts that can be cut to work?
Driveshaft for e9 with Getrag 265
- Thread starter halboyles
- Start date
I bought a used drive shaft on Ebay and sent it to California to shorten by 3.75 in. They completely rebuilt the drive shaft and sent it back works like a charm with my 265.
These guys may be able to sell you one already shortened:
www.driveshaftpro.com
e9coupe.com
DriveshaftPro // Driveshaft Repair in Southern California
Need 4 speed CS driveshaft
Looking for a driveshaft with good U joints from a 4 speed 72-74 coupe. I'll replace the center bearing, but the U joints must be snug and not notchy. If taken apart, halves must be MARKED so that I can assemble it as a factory balanced piece. If you have one left over (perhaps no longer...
e9coupe.com
Purchased an E9 standard drive shaft as if for a four speed and sent to : Oceanside was great they knew what to do.
Jeff Helton
Service Manager
Oceanside Driveline
760-439-9719
[email protected]
Jeff Helton
Service Manager
Oceanside Driveline
760-439-9719
[email protected]
Paul Cain gave them the dimensions, just be sure you have a standard guibo and an M5 guibo as the output flanges vary.These guys may be able to sell you one already shortened:
DriveshaftPro // Driveshaft Repair in Southern California
Need 4 speed CS driveshaft
Looking for a driveshaft with good U joints from a 4 speed 72-74 coupe. I'll replace the center bearing, but the U joints must be snug and not notchy. If taken apart, halves must be MARKED so that I can assemble it as a factory balanced piece. If you have one left over (perhaps no longer...