Hi guys
I am hopefully dropping my September 1973 , 4 speed driveshaft off to be shortened and balanced this week in preparation for the getrag 265 5 speed gearbox.
Can I just check how much should it be shortened by .
I think it is 3.75” but I am not 100% sure and I’d rather ask the question first , than ending up with a drive shaft too short .
Thanks.
Also I bought a new Guibo and center bearing from Walloth and Nesch are they acceptable ?
Just wondering as I think I remember someone mentioning one from a M5
I am hopefully dropping my September 1973 , 4 speed driveshaft off to be shortened and balanced this week in preparation for the getrag 265 5 speed gearbox.
Can I just check how much should it be shortened by .
I think it is 3.75” but I am not 100% sure and I’d rather ask the question first , than ending up with a drive shaft too short .
Thanks.
Also I bought a new Guibo and center bearing from Walloth and Nesch are they acceptable ?
Just wondering as I think I remember someone mentioning one from a M5