I’ve done a little research into getting these mounts made from milled aluminium. (Original part pictured below)
It is still in the planning stage and the current figure for a pair in smooth, unfinished aluminium is around $140USD which may decrease depending on volume.
These would be supplied unpainted so as to be finished to your taste and standard.
I am told that the aluminium being used to make them would best be suited to an anodised finish rather than powder coating.
If there is enough interest to get them made turn around would be some time in the early new year.
Let’s see where this goes...
It is still in the planning stage and the current figure for a pair in smooth, unfinished aluminium is around $140USD which may decrease depending on volume.
These would be supplied unpainted so as to be finished to your taste and standard.
I am told that the aluminium being used to make them would best be suited to an anodised finish rather than powder coating.
If there is enough interest to get them made turn around would be some time in the early new year.
Let’s see where this goes...
Attachments
Last edited: