Suspension Tension Rod Bushing

Discussion in 'E9 General Discussion' started by bavbob, Feb 13, 2018 at 9:01 AM.

  1. bavbob

    bavbob Active Member

    Messages:
    766
    Likes Received:
    34
    Trophy Points:
    28
    Location:
    Boston, Ma
    The seat for this on my car is slightly ovoid and also angled (bottom of ring is slightly forward of the top). The front washers on both sides are bent so I surmise some moron raised the car at this site. Can anyone confirm the angulation? Also, I plan on trying a pipe expander (gently to not over expand of course) to fix the ovoid shape, any other ideas?
     
  2. HB Chris

    HB Chris Well-Known Member Site Donor

    View My Garage
    Messages:
    9,114
    Likes Received:
    486
    Trophy Points:
    83
    Location:
    Huntington Beach, CA
    The tension strut uses dished washers at both ends, post a pic.
     

Share This Page